AB9001 Anybus X-gateway Profibus Communication Configuration Error

I’m attempting to use the AB9001 Anybus X-gateway Modbus-TCP (firmware version 1.13) with a siemens 315 PLC and project configured in TIA Portal using gsd file hmsa1837.gsd (v. 1.09).

We’ve set the profibus address to the same address in the TIA portal project and in the online webpage X-gateway configuration. However the PLC does not see the anybus module and the PLC cannot communicate through the module into the modbus network.

We are seeing a blinking (2 flashes) OP network red status light on the anybus module, seemingly representing that there is a profibus configuration error. We are also seeing a blinking red light on the MTCP seemingly representing a modbus timeout or transaction error.

Please advise, and thanks in advance!


A post was merged into an existing topic: AB9001 Profibus Configuration Error - PLC can’t reach Anybus X-Gateway