How can I assign the desired parameters?
I require reading with a ControlLogix L72 several ABB UMC100 equipment by Profibus, an example please.
Profibus DP Master module configuration to Ethernet IP (AB-7800-F).
I have an AB7800-F module to communicate 15 control relays (UMC100.3) of the ABB brand and integrate with a Plc ControlLogix L72 on ETHERNET IP. I do not find much information on the network to communicate these computers please need help, I have already downloaded the GSDs but I do not know how to assign the parameters has been configured 16 inputs and 12 outputs.
Hello,
I would take a look at the following document. It shows how to configure the unit with Control Logix.
Additionally, I would take a look at the support page for this unit. This contains all our information on the Anybus module.
https://www.anybus.com/support/file-doc-downloads/x-gateway-specific/?orderCode=AB7800