CAN@Net 100 communication help

I am connecting two CAN networks through a ethernet network. I’ve got both connected and programed but the I don’t have any mapping. I’m not sure how to configure the mapping to allow communication through the CAN@net NT100’s.

Hello @Lenny,

What are you looking for help with? A mapping is not required but can be used to filter traffic, other wise all messages should be forwarded.

Make sure you have the VCI drivers installed and the CAN Gateway Configurator software. Downloads and Documentation for Ixxat Products

The user manual covers general navigation and setup. 4-01-0332-20000-can-at-net-en.pdf (