CM CanOpen - ERR light single flash

Ok, thanks for the update!

Hello,
This link is not opening. It is having error.
Can you share manual.

I’m also facing same error. Please help me regarding that.

Sorry about that. Here is the manual:

CM CANopen User Manual (3.5 MB)

Hello Sir,
Referred the above manual.

Right now I’m working on S7-1200, CM CANopen & Zapi Motor Controller.

I’ve S7-1200 (1215 DC/DC/DC) & CM CANopen (021620-B) module.

I created an Electronic datasheet (EDS) file & added it to CM-CAN module.

I’ve downloaded a program to PLC & connected the CM CAN module (with CAN device) to PLC.

I want to know how I should access STATUS WORD & CONTROL WORD of CAN devices ?

Also how to check if the communication is done or not ?

And how to send values to the CAN device ?

Right now CM module is having Fatal error when connected to one slave and Warning Limit reached error when no CAN device connected.

Baud Rates are matched. Also terminating resistors (120 Ohm) connected at termination ends.

Kindly support for the same.

Dear Sir,
Kindly support for the same.
How to overcome this error & send data PDO(transmit) from PLC to CAN device?