Having an issue, Using Anybus Gateway to communicate between a ControlLogix PLC and a Siemens.
Issue us The IP is reset on powerloss, is there a way to Save the config, to re-establish to the desired IP address on power restoration?
Hello @TroyKebler,
If the dip switches are on this address will be set on boot. Make sure all dip switches, for the IP address, are in the off position and then set the address using IP config.
Deryck
Yes they are all off, and the IP has been set with ipconfig. Then downloaded. We have other anybus gateways installed that seem to be fine on power loss. We are investigating, thank you for the response, I will reply here, with more questions as they arise.
Troy Kebler