I’m new with anybus. I would like to connect my ET200 (profinet) to the anybus Xgateway AB7650-F device and translate the protocol to Modbus TCP/IP.
Can someone help me please. How do I start? Examples or tutorials would help a lot.
Thanks in advance.
Hello @hagenimana,
You can find documentation including application notes for adding this module in step 7 and TIA on the AB7650 files and documents page.
I recommend starting with this documentation.
Let me know if you have any questions.
Regards,
Deryck
Hi,
I just went through some documents.
Do I need any Siemens Software to first configure the ET200s?
My solution was to connect some sensors to the ET200s then use Anybus to do all the configurations and communication.
Thanks in Advance.
Regards,
Yves
Hi,
Yes the gateway is only a IO slave device you will need to configure the communication to it from the master device. So you will need to use the Siemens software to set the plc up to read the data from the gateway.
Regards,
Deryck