Configure LAN device to get internet access through Flexy WAN

[landersson]

If I have a device connected to a Flexy LAN port, shouldn’t I be able to configure the flexy to gibe that device internet access?

[deryck_hms]

Hi @landersson,

You will need to edit the settings on the flexy to provide internet access.

Allow internet to LAN devices on Flexy205

@anonzsaorytb To allow internet to LAN devices on the Flexy, you will need to change parameters in the interface to allow for WAN TO LAN traffic. Instructions: Firmware < 12.2 Does not apply to Flexy205 You can follow the following KB article to allow internet to LAN devices: Firmware > 12.2 The graphical user interface changes on the newer firmware versions but the steps are the same. 1 - Activate the NAT feature on the eWON: Navigate to: Setup/System/Communication/Networking/Routing •…

[landersson]

can this work without turning on the DHCP server feature on the Flexy?

[deryck_hms]

Yes this works with static IP addresses. In fact you need to make sure you set the ewon’s LAN IP address as the gateway for the devices. This is required for both remote access and for them to get internet access.

[landersson]

ok, on that topic.
I have another device that is made for DHCP setup only.
If I have the Flexy acting as the DHCP server for those LAN devices, how do I specify the default gateway in the DHCP setup.
My COM cfg settings are as this:

[deryck_hms]

Hello @landersson ,

The ewon will use its LAN IP as the gateway address. No dedicated parameter for the gateway address is available.

DHCP Server on LAN (windows.net)