Connection error (profinet master simulator connected to microzed board(anybus ip) as slave 2

Anybus Support Embedded
#1

Hi,

I followed the below points yet the connection between master and slave was not established.

  1. Installed profinet master simulator and changed the IP, subnet and default gateway to that of the Ethernet adaptor, a screenshot for the same is provided
  2. Opened and Configured GSDML-V2.34-HMS-CompactCom-40-PIR-20180417, connected ADI1 to slot 1 and ADI2 to slot 2 and got the attached error
    Could you let me know if there are any other steps that are required to make a successful connection?

ThanksIP%20addrprofinet%20master%20simulator%20error

#2

A post was merged into an existing topic: Connection error (profinet master simulator connected to microzed board(anybus ip) as slave

#4