Good evening, is it possible to connect to an S5 via evcom?
Thank you
Kirty
If it’s one of the ones listed below that should be possible
Hello, I can read and write in my S5 controller but can I have remote access to my controller via my Step5 software? and using EVCOM.
I did not find a way …
For info I communicate to an S7-200 via com1 of my flexy 205 and S5 via com2.
thank you
Kirty
Are you able to talk to the S7-200 through EVCOM?
Good evening, no I can not connect to the s7-200 via evcom.
And when I test the communication of the port Evcom I see that com2 port is activated and crash my S5 !!!
For communication with the S7 and the s5 just with the tcp / ip
++
Kirty
Did you already go through this doc and set up the ewon to work with Evcom?
also are you sure that all the settings in here are correct?
hello, i have tested the communication on the s7 which is on com1 flexy 205 port and on the S5 which is on the port com2 sy flexy 205 and nothing communicates.
Kirty
It looks like you have the port disabled on the bottom, can you try and hit enable port and try again?
this doc might also be a little more helpful for siemens devices
Good evening, I activated the com port, the screenshot was there to show the config used.
The s7-200 is in PPI not in MPI and the AS511 S5 loop current.
++
Thank you
Kirty
Was the other doc that I posted on eVcom and Siemens any help?
If not can we try and setup a time where I can take a look on teamviewer tomorrow?
[Ok, tell me the time
I installed teamviewer 14
Thank you
Kirty
Does 130 EST work for you?
???
Hi Kirty,
Sorry for any confusion, I didn’t hear back from you after asking about meeting at 130. Are you free for me to take a look now?
yes
What’s your teamviewer id?
[hidden]
what’s the password