Gateway off line

It looks like the DeviceNet side is online, but the Profibus is not. Is the control/status word enable on the Profibus side?

I made sure that both sides are the same .
Bryce

OK, that means that there is another issue with the Profibus network, probably the Fanuc robot is not configured correctly as the master.

I would recommend contacting whoever sold you the machine and tell them what I’ve told you, and if they have questions, have them contact us. I am not going to be able to fix this because our device is a slave-slave device, so the configuration for the DeviceNet and Profibus networks need to be configured on the master of those networks.

What does the slave need to see from the master to make it start to function.
As a diagnostic test what would happen if the profibus cable was removed from a properly functioning system? What if the robot was powered down and the Lathe stayed powered up?
Bryce

We have already had people from Funuc come and look at it. They say that the robot is configured correctly.

If the control/status word is disabled it will automatically start in run mode.

The Online light would turn from green to either red or off. The offline light would turn from off to red.

Same result.

Can you take a screenshot of the Diagnostic page in the gateway?

I am not understanding what you mean by a diagnostics page.
Bryce

Just need to know where to find the diagnostics page.
Bryce

Pleaes disregard, there is no diagnostics page on this particular model.