Hi,
Thanks for the info. But anyway after configuring through the hyperterminal it still doesn’t communicate on the config port. I can connect throught the profibus configuration port, with the Anybus tool, but not with the configuration manager.
Hi,
Thanks for the info. But anyway after configuring through the hyperterminal it still doesn’t communicate on the config port. I can connect throught the profibus configuration port, with the Anybus tool, but not with the configuration manager.
Hi @gsevilla,
Were you rebooting the devce?
After you setup hyperterminal you need to power cycle the device. When it initializes it will start printing to the terminal.