Hello,
I’d like to ask for help with hms tci tool ,
I’ve downloaded it from your website but i cannot run it i’m getting error " The tool did not find the command line parameter -tpf".
Could you tell me what might cause this fault?
Hello @misqowiec,
This is not something we are very familiar with here on the forum I would recommend also reaching out though mysupport.hms.se
What I have found regarding the tool is that it uses the Siemens TIA portal TCI interface. Is this installed?
Deryck
Hi,
I’ll try to call support tomorrow, i think i 've got this tci software since other company tool is working fine.