TX | Bit Error when connecting 2 USB-to-CAN FDs together

I cannot get a successful transfer when connecting to USB-to-CAN devices together and control them with canAnalyzer3 Mini. I must be missing something but I just cannot figure out what.

[Setup]
2x PCs with the following setup:

They are connected together with a pass-through gender changer.

You need to make sure CAN_H is connected to CAN_H and CAN_L to CAN_L.

image

I actually just did the same myself and it works:

Make sure the baud rates are the same.

Thank you.

I was pretty sure I had set things up the same; connecting everything together again this morning paying closer attention to settings worked.

OK great! Maybe the baud rate was different. Autobaud does not always work perfectly.