Use the Flex Wifi Card (FLB3271) to access the Lan port

Ewon Support
#1

It is possible to Use the Flex Wifi Card (FLB3271) as access point to devices connected to the Lan ports of the Flexy. Without starting eCatcher.

#2

@whockensmith

You cannot necessarily broadcast it as an access point however you have two other options.

  1. NAT 1:1
    You can set up NAT 1:1 translations which would allow you to map your LAN devices to your wifi network. The only thing to be aware of is that in order to see the devices you would need to be on the same wifi network as the eWON WAN.
    NAT 1:1 on the Flexy

  2. Anybus Wireless Bolt
    You can use a wireless bolt to create an AP on the LAN of your eWON. The only caveat is that this is a secondary piece of hardware to be used in conjuction with the eWON.
    https://www.anybus.com/products/wireless-index/anybus-wireless-bolt

#4

The Flexy Wan Wifi netowrk is 192.186.0.x the Device on Lan network is 192.168.1.121…

Enabled Nat 1:1 (NAT 1:1 Map to WAN) Mapped 192.168.0.50 to 192.168.1.121 not able to ping the device with from PC 192.168.0.111 on the WIFI Wan network

Will the devices require there gateway address of the Ewon switch address?

#5

@whockensmith

Did you update all of the configuration settings that were listed in that post?

#7

Jordan
i am not able to get NAT to work. i checked and believe have all the setting correct. Any suggestions. or can you remote in and check.

#8

@whockensmith

Do you have direct line we can give a call? How about a Teamviewer connection?