Are you ok with just leaving them both on static addresses?
Static IP address is fine but I need it to work in the 15.128.XXX.XXX range.
Is there any chance that you took a backup of your device after you got it working? I canât imagine that if there was no changes to the Cosy that you would lose an already working configuration unless something was changed on your network
somehow WANITFPORT got changed back to 1 i set it to 2 and it is working now
1 Like
Unfortunately no my backup is prior to getting the NAT working. Our IT department swore they didnât mess with anything. Also even when i put it on the same subnet and the NAT is working it still does not reply to a ping from the WAN side
Would you suggest doing a factory reset and starting over?
Hi Brad,
Just saw your response. Not sure what mightâve cause that value to change, but I would recommend taking a backup of the device where itâs at right now just in case something else changes again