WAN interface parameterization using Basic IDE script

[Fateh]

Hi all,

I would like to know if there is any way to change the WAN interface paremeter value ( switch from “No Internet acces” to “Ethernet INTERNET connection”) and perform internet connection test with DHCP address allocation (as what we could do with Wizards) using basic IDE script.

If yes , could you please tell me wich commands allow to do that.

Thank you

@Fateh

[Tim_hms]

Hi @Fateh,

I think the post below has what you’re looking for:

Disable WAN with Digital Input

@Ryan_Nordhus Cosy 141 - DI / DO To configure the digital input, you can do this through the internet wizard as seen by our getting started video step 2 (180 seconds): https://youtu.be/viQR6U2qMHU?t=180 The digital output for the cosy 141 is limited to the VPN tunnel only as seen by our manual on page 10: [image] When the VPN tunnel is established then the digital output will be in an ON state. This is still a good check on whether you have internet because the eWON will disconnect/conne…

-Tim

[Fateh]

Thak you for these informations.

Kind regards,
@Fateh

[Tim_hms]

You’re welcome, let me know if you have issues with this