Hello,
I am currently using three bolts within my cell. 1 is AP and the two other are Clients. The Access Point is connected into an unmanaged switch that allows for all the devices in that control panel to talk to the other control panel throughout the cell. We are using 1734-Aentr allen bradley devices for the I/O and unmanaged switches for the other two control panels with the other two bolts connecting into them as clients. The problem I am running into is that when i connect the clients into just the 1734 device everything stays connected but once i daisy chain the connection into the unmanaged switches i lose connection for .5 second over and over which wont allow my plc to run the program correctly. I am not necessarily sure if this is the Bolt device at fault but i wanted to see if anyone would have any information on this topic. I did the setup with the wlan easy config.
my ip addresses are:
AP-192.168.1.61
Client 1 - 192.168.1.62
client 2 - 192.168.1.63
Subnet - 255.255.255.0
GateWay - 192.168.1.1
PLC Ip - 192.168.1.10, 255.255.255.0(AP is connected to this)
1734 device 1 - 192.168.1.23(Client 2 is connected to this)
1734 device 2 - 192.168.1.28(client 1 is connected to this)