Ewon Flexy 205 won't reset after

[glwlash]

Hi HMS team,

I lost connection with a Flexy 205 while I was performing a firmware update since then I have no more response from it. I try to reboot it and still nothing.

I tried a level 1 reset. But the led never when to blinking mode after 30 sec (3. Wait approximately 30 seconds until the USR LED blinks red 1x per second).

I also try the level 2 reset and again it doesn’t work.

When performing the reset procedure the USR led turn red after after 5-6 sec and nothing happend at 30 or 35 sec.

What can I do to restore my Ewon.

Thanks,
Guillaume

[Tim_hms]

Hi @glwlash,

Can you try and go through the recovery procedure described below:

General Upgrade and Recovery Guide

NOTE: Read First If you’re on firmware 11.0 or higher you can update your firmware through eBuddy, FTP, or a Recovery. You will need to perform intermediate updates for these. Ex: if you’re on 11.0, you’ll need to go to 12.0 before you can update to 13.0. If your firmware is lower than 11.0 then it is a requirement to do the firmware upgrade through a recovery In order to do any of this, you need to be the “adm” user or a user with these permissions [image] Firmware download link: https:/…

-Tim

[glwlash]

Hi @Tim_hms,

Thank you ! The recovery procedure worked!

Regards,
Guillaume

[Tim_hms]

Glad to hear it’s working!