Hi,
We are trying to monitor the communication between a third party device and HMS-EN2MB-R. How can this be achieved using the provided BOOLEAN as shown in the image below? Or what are the ways to do this?
Thanks!
Hi,
We are trying to monitor the communication between a third party device and HMS-EN2MB-R. How can this be achieved using the provided BOOLEAN as shown in the image below? Or what are the ways to do this?
Thanks!
Hi @Abel,
Do do you have a manual for that modbus device that you’re trying to read from? If it’s a boolean it’s probably a coil that you’re trying to read from.
-Tim
Hi @Tim_hms ,
This Boolean belongs to HMS-EN2MB-R Linking device. It does not belong to the third party device.
Oh sorry I was confused about what we were looking at, I think that bit may be tied to the status word if you have the control/status word enabled