Hello.
I am looking for some help with setting up addresses and all necessary stuff for modbus communication protocol, using RS485.
I have a weight measure that has table of around 250 double word addresses. Ofc I will not have to use them all, however if I will need to use for example ADR 027, 112 and 206 I wonder how should I set it up in ACM.
I downloaded your ipconfig program, where I found the device on profinet. I also downloaded GSDML for anybus I just have to figure out how big IO modules do I need there, but I am pretty new with modbus communication that I should use for the communication between the profinet, anybus and weight measurement.
I read ACM manual that is describing what each operation means, but I am looking for a little more specific directions how to set this step by step.
Right now I set up fieldbus type to profinet IO, then I checked communicator RS232/422/485 if physical interface is set to serial which was and then I changed parameters for subnetwork parity, bitrate etc… Now I should probably start setting up the addresses, but I am not really sure how to start properly.
I would be very grateful for each advice. Thank you
Regards
Morvis