Hi,
I’m having some issues with changing the operation mode of my Anybus X gateway.
The article number is AB7808-F.
I’m at the point where I want to setup my profibus configuration via Nettool for profibus.
Just made an offline configuration that I want to download.
While choosing my transport path I get the following error message:
I read in the manual that you need to change the operation mode of the Anybus X Gateway to stop before you can download your configuration.
Therefore I downloaded Hyper terminal and Anybus Configuration Manager.
If I change the operation mode in Hyper terminal, nothing changes.
When I tried to change the operation mode in Anybus Configuration Manager I get the following error:
The current state is offline.
I have communication because I can retrieve the configuration from the gateway.
My profibus master is configured as shown below:
Slave is configured like:
Is there any reason why I can’t change the operation mode in this state or is there something wrong with the steps I’ve took?
Kind regards,
Michaël Vanhee