Hi,
I have a problem with a legacy Netbiter module (the WS 200).
The Netbiter is used to send alarms via SMS and it was working properly. I tried adding the SNMP function but it didn’t work, I thought about updating the firmware via the webpage and that’s when the problem happened.
I updated the Kernel, reboot and logged in again using the IP address provided by IP Config,
I did the same with the firmware, but after I reboot I can’t seem to have access via the webpage.
The odd think is that the LED on the module are blinking just normally, and the IP Config is able to find the Netbiter if I were to do a scan, but when I use the IP address provided, I’m faced with
“This site can’t be reached, IP address took too long to respond.”
Do you guys think that using a serial connexion can solve the problem? else I need your help if possible.
Thanks in advance.
Best regards